Our Piping Engineering Training is entirely based on ASME B31.3 code. Our Students acquire knowledge that is equivalent to about two years industry related experience. Students are exposed to the latest piping techniques as related to the oil & gas industry.

Piping Design & Layout

Piping Design & Layout

This Course introduces you to the fundamentals of Piping Engineering. It also reaches out into the art of Piping Layout and Design. It is a complete Course as students will be taught how to draw and interprete piping systems.
You will learn how to produce GA drawings, Isometrics, Unit plot plans by hand and via AutoCAD, how to use the AutoCAD software, how to route and analyze piping systems and make adequate recommendations.

6 lessons 0 minutes Intermediate
Stress analysis/CAESER II

Stress analysis/CAESER II

This Course introduces students to the static and dynamic loadings that occur on a piping system. In here, students must make several calculations and recommendations that will ensure that the Piping stresses are within code allowable limits, the Piping end reactions are within allowable limit, the Piping system is properly supported. You will also be introduced to the CAESER II software which is used to simulate both static and dynamic loadings on a piping system and simulate the effects of supports on them.

1 lesson 2 hours Intermediate
AVEVA PDMS

AVEVA PDMS

Tekniprep offers you the unique opportunity to learn how to make Piping Layout representations in 3D using Plant Design Management System (PDMS). We introduce our students to representations in Piping, Equipment, Structures and so on. We also teach you how to extract Isometric drawings from your 3D drawings.

1 lesson 3.67 hours Advanced